maelstrom wrote:Ok, something that happened during a recent performance whilst loading
a sample into flex:
Booting up into the testmenu would state following
does also not dissappear ever since, though empty reset was done
Any of you guys know what ATA could mean?
Will send that to elektron.
-mael
ps.: no, did not try to bend it in any way.... OS 0.99B
I do have this problem as well. I did "Test mode" and it says "ATA fail". I also did "Empty reset", but this doesn´t effect the Compact flash drive, so it doesn´t seem to solve the problem.
Since then the OT freezes everytime I do something with the Compact flash card via "Projects" (set restore point/change project/save new project/etc.). So I am not able to do much since then. I will try to format my card (original) now and see if that helps.
I rebooted more than once, but it doesn´t help.
I think I also know when this happened, so this might be a suggestion to everyone else to be careful about: I did a backup on my computer (intel mac osx 10.5.8) with "super duper" and the OT was connected via USB, but not enabled (System/enable USB Disk) through the OT (ejected on the computer). While I did the backup I saw that the scrolling bar on the OT´s display kept going and going and wouldn´t stop until the OT froze.
So, it might be a good idea to always disconnect the usb cable from the OT to the computer when not needed, especially when you do things like backups/repair permissions/etc.. I didn´t use leopards timemachine for this specific backup, so I don´t know if this would make a difference.
I will write elektron a bug report, but I thought I let you know, so that everyone is aware that this might cause a problem.
I hope I will get this working again, because I can´t do much if I can´t use my drive on the OT anymore.
Edit: I just did "enable USB disk" on the OT, but the drive doesn´t show up on my computer anymore. It feezes the OT as well then. Uuhh, now this is not good. Seems like I am not really able to use my OT for now and wait for a fix.